How much does drywall installation cost in Albuquerque, NM?

Most Albuquerque homeowners spend between $1,400 – $3,300 on drywall installation, with an average around $2,350. Local labor prices 6% below the national average, so Albuquerque quotes tend to land at the lower end of national ranges.

Why is drywall installation more or less expensive in Albuquerque than elsewhere?

Licensed trade labor in Albuquerque runs about 94% of the national average, and the best crews book out fastest in spring and early summer. New Mexico weather drives material choices here, so ask contractors what they install most often in Albuquerque and why.

Do I need a permit for drywall installation in Albuquerque, New Mexico?

Most Albuquerque, NM projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Albuquerque?

Get at least three written quotes from licensed, insured New Mexico contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Albuquerque metro market.

How much does drywall installation cost in 2026?

Most homeowners pay between $1,500 and $3,500, with a national average near $2,500. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per square foot?

Installed pricing usually runs $1.50 to $3.50 per square foot, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-square foot price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Drywall Installation/Albuquerque, NM

Albuquerque metro · New Mexico

Drywall Installation cost in Albuquerque, NM

Albuquerque homeowners typically pay $1,400 – $3,300 for drywall installation. Local labor and materials price 6% below the national average.

Get my Albuquerque estimate Use the Albuquerque calculator

Albuquerque average

$2,350

Typical low

$1,400

Typical high

$3,300

Per square foot

$1 – $3

Sample ZIP

What drives Albuquerque pricing

Local labor

Licensed trade labor in Albuquerque runs about 94% of the national average, and the best crews book out fastest in spring and early summer.

Permits & code

Most Albuquerque, NM projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not.

Climate & conditions

New Mexico weather drives material choices here, so ask contractors what they install most often in Albuquerque and why.

Instant cost calculator

Adjust the inputs to see live pricing

Drywall area (sq ft)1,000 square feet

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$1,387 – $1,900

Most homeowners pay around $1,644

Compare quality / material level

Cost by material in Albuquerque

Installed Albuquerque pricing per square foot.

Option	Installed cost	Pros	Cons
Hang only	$1 – $2	—	—
Hang, tape and finish (Level 4)	$2 – $3	—	—
Level 5 smooth finish	$3 – $3	—	—
Moisture / fire-rated assemblies	$3 – $5	—	—

Where the money goes in Albuquerque

A typical $2,350 Albuquerque project, broken down by line item.

Labor0.45% · $11
Materials0.38% · $9
Permits & inspections0.05% · $1
Overhead & profit0.12% · $3

Common add-ons

Extras that show up on Albuquerque quotes but rarely in the headline price.

Ceiling texture removal

$470 – $2,350

Insulation before board

$375 – $1,900

Corner bead and archways

$140 – $750

Painting after finish

$470 – $2,350

Ways to save in Albuquerque

Order board delivered to the room to avoid carry charges.
Accept a Level 4 finish unless walls take raking light.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Albuquerque FAQs

Get a Albuquerque price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your NM ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Albuquerque research

Best drywall installation companies in Albuquerque Drywall Installation permits in New Mexico Drywall Installation near me All New Mexico prices

More New Mexico cities

Santa Fe Las Cruces Rio Rancho

Other project costs in Albuquerque

Fence Installation in Albuquerque

$1,410 – $3,760

Roof Replacement in Albuquerque

$7,990 – $31,960

Kitchen Remodel in Albuquerque

$16,920 – $89,300

HVAC Replacement in Albuquerque

$5,170 – $16,920

Deck Building in Albuquerque

$4,136 – $11,280

Window Replacement in Albuquerque

$423 – $1,410

See every Albuquerque cost guide