How much does electrical panel upgrade cost in Kent, WA?

Most Kent homeowners spend between $2,150 – $5,350 on electrical panel upgrade, with an average around $3,450. Local labor prices 19% above the national average, so Kent quotes tend to land at the higher end of national ranges.

Why is electrical panel upgrade more or less expensive in Kent than elsewhere?

South King County crews price just under the Seattle core. Wet climate favors fiber cement and treated wood.

Do I need a permit for electrical panel upgrade in Kent, Washington?

City permits required for remodels and exterior work. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Kent?

Get at least three written quotes from licensed, insured Washington contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Seattle market.

How much does a 200 amp panel upgrade cost?

$2,000 to $4,500 typically, or $2,800 to $6,000 if the meter base and service entrance also need replacing.

How long does a panel upgrade take?

One day for the electrical work, with power out four to eight hours. Utility scheduling and inspection may spread it over a few days.

Do I need 200 amps for an EV charger?

Usually. A Level 2 charger draws 40 to 60 amps; most 100 amp services cannot support it without load management.

Is a permit required?

Always. The utility will not reconnect without an inspection sign-off, and unpermitted work surfaces during a home sale.

What are Federal Pacific and Zinsco panels?

Obsolete panels with breakers that fail to trip. Insurers often refuse coverage and replacement is strongly recommended regardless of capacity.

Can I just add a subpanel instead?

A subpanel adds circuit space, not capacity. If your total service is maxed out, you still need the main upgrade.

Home/Cost guides/Electrical Panel Upgrade/Kent, WA

Seattle · Washington

Electrical Panel Upgrade cost in Kent, WA

Kent homeowners typically pay $2,150 – $5,350 for electrical panel upgrade. Local labor and materials price 19% above the national average.

Get my Kent estimate Use the Kent calculator

Kent average

$3,450

Typical low

$2,150

Typical high

$5,350

Per panel

$1,550 – $7,150

Sample ZIP

98030

What drives Kent pricing

Local labor

South King County crews price just under the Seattle core.

Permits & code

City permits required for remodels and exterior work.

Climate & conditions

Wet climate favors fiber cement and treated wood.

Instant cost calculator

Adjust the inputs to see live pricing

Panels to upgrade1 panel

Target service size

Service entrance

Panel location

Code corrections

Estimated project cost

$1,550 – $3,000

Most homeowners pay around $2,275

Compare target service size

Cost by material in Kent

Installed Kent pricing per panel.

Option	Installed cost	Pros	Cons
100 amp service	$1,550 – $3,000	Fine for small homes with gas heat	No headroom for EV or heat pump
150 amp service	$2,150 – $3,800	Middle ground	Often costs nearly the same as 200
200 amp service	$2,400 – $5,350	The modern standard, supports EV and electrification	May require new meter base
400 amp service	$4,750 – $10,700	Large homes, shops, multiple EVs	Utility coordination and two panels
Subpanel	$715 – $2,400	Cheap way to add circuits	Does not increase total service capacity

Where the money goes in Kent

A typical $3,450 Kent project, broken down by line item.

Labor48% · $1,656
Panel and breakers27% · $932
Service entrance materials15% · $518
Permits and inspection10% · $345

Common add-ons

Extras that show up on Kent quotes but rarely in the headline price.

EV charger circuit

$595 – $2,400

Whole-home surge protector

$300 – $835

Generator interlock or transfer switch

$475 – $3,000

Grounding rod system update

$240 – $950

AFCI/GFCI breaker upgrades

Per breaker

$48 – $145

Ways to save in Kent

Go straight to 200 amp — the incremental cost over 150 is small and you will not repeat the job.
Bundle EV charger, surge protector and any new circuits into the same permit and visit.
Check for utility and federal electrification rebates before you sign.
Get three bids; panel pricing varies more between electricians than almost any other trade.
Ask about keeping the panel in its existing location to avoid relocation cost.

Kent FAQs

Get a Kent price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your WA ZIP code — then connect you with vetted local pros.

Get electrician quotes

More Kent research

Best electrical panel upgrade companies in Kent Electrical Panel Upgrade permits in Washington Electrical Panel Upgrade near me All Washington prices

Electrical Panel Upgrade cost near Kent

Electrical Panel Upgrade cost in Seattle, WA

$2,313 – $5,755

Electrical Panel Upgrade cost in Bellevue, WA

$2,385 – $5,934

Electrical Panel Upgrade cost in Tacoma, WA

$2,078 – $5,170

Electrical Panel Upgrade cost in Everett, WA

$2,132 – $5,305

Electrical Panel Upgrade cost in Renton, WA

$2,168 – $5,395

More Washington cities

Spokane Vancouver Olympia

Other project costs in Kent

Fence Installation in Kent

$1,785 – $4,760

Roof Replacement in Kent

$10,115 – $40,460

Kitchen Remodel in Kent

$21,420 – $113,050

HVAC Replacement in Kent

$6,545 – $21,420

Deck Building in Kent

$5,236 – $14,280

Window Replacement in Kent

$536 – $1,785

See every Kent cost guide