How much does furnace repair cost in Green Bay, WI?

Most Green Bay homeowners spend between $145 – $1,350 on furnace repair, with an average around $750. Local labor prices 3% below the national average, so Green Bay quotes tend to land at the lower end of national ranges.

Why is furnace repair more or less expensive in Green Bay than elsewhere?

Licensed trade labor in Green Bay runs about 97% of the national average, and the best crews book out fastest in spring and early summer. Wisconsin weather drives material choices here, so ask contractors what they install most often in Green Bay and why.

Do I need a permit for furnace repair in Green Bay, Wisconsin?

Most Green Bay, WI projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Green Bay?

Get at least three written quotes from licensed, insured Wisconsin contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Green Bay metro market.

How much does furnace repair cost in 2026?

Most homeowners pay between $150 and $1,400, with a national average near $775. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per job?

Installed pricing usually runs $150.00 to $1,400.00 per job, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-job price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Furnace Repair/Green Bay, WI

Green Bay metro · Wisconsin

Furnace Repair cost in Green Bay, WI

Green Bay homeowners typically pay $145 – $1,350 for furnace repair. Local labor and materials price 3% below the national average.

Get my Green Bay estimate Use the Green Bay calculator

Green Bay average

$750

Typical low

$145

Typical high

$1,350

Per job

$145 – $1,350

Sample ZIP

What drives Green Bay pricing

Local labor

Licensed trade labor in Green Bay runs about 97% of the national average, and the best crews book out fastest in spring and early summer.

Permits & code

Most Green Bay, WI projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not.

Climate & conditions

Wisconsin weather drives material choices here, so ask contractors what they install most often in Green Bay and why.

Instant cost calculator

Adjust the inputs to see live pricing

Number of repairs1 job

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$442 – $608

Most homeowners pay around $525

Compare quality / material level

Cost by material in Green Bay

Installed Green Bay pricing per job.

Option	Installed cost	Pros	Cons
Diagnostic and tune-up	$465 – $640	—	—
Igniter or flame sensor	$640 – $840	—	—
Blower motor or control board	$840 – $1,100	—	—
Heat exchanger replacement	$1,100 – $1,500	—	—

Where the money goes in Green Bay

A typical $750 Green Bay project, broken down by line item.

Labor0.45% · $3
Materials0.38% · $3
Permits & inspections0.05% · $0
Overhead & profit0.12% · $1

Common add-ons

Extras that show up on Green Bay quotes but rarely in the headline price.

Annual tune-up

$97 – $245

Thermostat replacement

$145 – $485

Duct sealing

$485 – $1,950

Carbon monoxide detectors

$49 – $195

Ways to save in Green Bay

Book a fall tune-up before the first cold snap to avoid emergency rates.
Ask whether the part is under manufacturer warranty before approving.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Green Bay FAQs

Get a Green Bay price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your WI ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Green Bay research

Best furnace repair companies in Green Bay Furnace Repair permits in Wisconsin Furnace Repair near me All Wisconsin prices

More Wisconsin cities

Milwaukee Madison Kenosha Appleton

Other project costs in Green Bay

Fence Installation in Green Bay

$1,455 – $3,880

Roof Replacement in Green Bay

$8,245 – $32,980

Kitchen Remodel in Green Bay

$17,460 – $92,150

HVAC Replacement in Green Bay

$5,335 – $17,460

Deck Building in Green Bay

$4,268 – $11,640

Window Replacement in Green Bay

$437 – $1,455

See every Green Bay cost guide