How much does furnace repair cost in Memphis, TN?

Most Memphis homeowners spend between $140 – $1,300 on furnace repair, with an average around $715. Local labor prices 8% below the national average, so Memphis quotes tend to land at the lower end of national ranges.

Why is furnace repair more or less expensive in Memphis than elsewhere?

Licensed trade labor in Memphis runs about 92% of the national average, and the best crews book out fastest in spring and early summer. Tennessee weather drives material choices here, so ask contractors what they install most often in Memphis and why.

Do I need a permit for furnace repair in Memphis, Tennessee?

Most Memphis, TN projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Memphis?

Get at least three written quotes from licensed, insured Tennessee contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Memphis metro market.

How much does furnace repair cost in 2026?

Most homeowners pay between $150 and $1,400, with a national average near $775. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per job?

Installed pricing usually runs $150.00 to $1,400.00 per job, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-job price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Furnace Repair/Memphis, TN

Memphis metro · Tennessee

Furnace Repair cost in Memphis, TN

Memphis homeowners typically pay $140 – $1,300 for furnace repair. Local labor and materials price 8% below the national average.

Get my Memphis estimate Use the Memphis calculator

Memphis average

$715

Typical low

$140

Typical high

$1,300

Per job

$140 – $1,300

Sample ZIP

What drives Memphis pricing

Local labor

Licensed trade labor in Memphis runs about 92% of the national average, and the best crews book out fastest in spring and early summer.

Permits & code

Most Memphis, TN projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not.

Climate & conditions

Tennessee weather drives material choices here, so ask contractors what they install most often in Memphis and why.

Instant cost calculator

Adjust the inputs to see live pricing

Number of repairs1 job

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$418 – $575

Most homeowners pay around $496

Compare quality / material level

Cost by material in Memphis

Installed Memphis pricing per job.

Option	Installed cost	Pros	Cons
Diagnostic and tune-up	$440 – $605	—	—
Igniter or flame sensor	$605 – $800	—	—
Blower motor or control board	$800 – $1,050	—	—
Heat exchanger replacement	$1,050 – $1,450	—	—

Where the money goes in Memphis

A typical $715 Memphis project, broken down by line item.

Labor0.45% · $3
Materials0.38% · $3
Permits & inspections0.05% · $0
Overhead & profit0.12% · $1

Common add-ons

Extras that show up on Memphis quotes but rarely in the headline price.

Annual tune-up

$92 – $230

Thermostat replacement

$140 – $460

Duct sealing

$460 – $1,850

Carbon monoxide detectors

$46 – $185

Ways to save in Memphis

Book a fall tune-up before the first cold snap to avoid emergency rates.
Ask whether the part is under manufacturer warranty before approving.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Memphis FAQs

Get a Memphis price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your TN ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Memphis research

Best furnace repair companies in Memphis Furnace Repair permits in Tennessee Furnace Repair near me All Tennessee prices

More Tennessee cities

Nashville Knoxville Chattanooga Franklin Murfreesboro

Other project costs in Memphis

Fence Installation in Memphis

$1,380 – $3,680

Roof Replacement in Memphis

$7,820 – $31,280

Kitchen Remodel in Memphis

$16,560 – $87,400

HVAC Replacement in Memphis

$5,060 – $16,560

Deck Building in Memphis

$4,048 – $11,040

Window Replacement in Memphis

$414 – $1,380

See every Memphis cost guide