How much does radon mitigation cost in Great Falls, MT?

Most Great Falls homeowners spend between $890 – $2,500 on radon mitigation, with an average around $1,700. Local labor prices 1% below the national average, so Great Falls quotes tend to land at the lower end of national ranges.

Why is radon mitigation more or less expensive in Great Falls than elsewhere?

Licensed trade labor in Great Falls runs about 99% of the national average, and the best crews book out fastest in spring and early summer. Montana weather drives material choices here, so ask contractors what they install most often in Great Falls and why.

Do I need a permit for radon mitigation in Great Falls, Montana?

Most Great Falls, MT projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Great Falls?

Get at least three written quotes from licensed, insured Montana contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Great Falls metro market.

How much does radon mitigation cost in 2026?

Most homeowners pay between $900 and $2,500, with a national average near $1,700. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per system?

Installed pricing usually runs $900.00 to $2,500.00 per system, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-system price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Radon Mitigation/Great Falls, MT

Great Falls metro · Montana

Radon Mitigation cost in Great Falls, MT

Great Falls homeowners typically pay $890 – $2,500 for radon mitigation. Local labor and materials price 1% below the national average.

Get my Great Falls estimate Use the Great Falls calculator

Great Falls average

$1,700

Typical low

$890

Typical high

$2,500

Per system

$890 – $2,500

Sample ZIP

What drives Great Falls pricing

Local labor

Licensed trade labor in Great Falls runs about 99% of the national average, and the best crews book out fastest in spring and early summer.

Permits & code

Most Great Falls, MT projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not.

Climate & conditions

Montana weather drives material choices here, so ask contractors what they install most often in Great Falls and why.

Instant cost calculator

Adjust the inputs to see live pricing

Number of suction points1 system

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$998 – $1,378

Most homeowners pay around $1,188

Compare quality / material level

Cost by material in Great Falls

Installed Great Falls pricing per system.

Option	Installed cost	Pros	Cons
Single-point sub-slab system	$1,050 – $1,450	—	—
Sub-slab with sealing	$1,450 – $1,900	—	—
Crawlspace membrane system	$1,900 – $2,450	—	—
Multi-point system with monitoring	$2,450 – $3,350	—	—

Where the money goes in Great Falls

A typical $1,700 Great Falls project, broken down by line item.

Labor0.45% · $8
Materials0.38% · $6
Permits & inspections0.05% · $1
Overhead & profit0.12% · $2

Common add-ons

Extras that show up on Great Falls quotes but rarely in the headline price.

Post-mitigation testing

$150 – $295

Crawlspace vapor barrier

$1,500 – $4,950

Sump pit sealing

$200 – $790

Continuous radon monitor

$150 – $395

Ways to save in Great Falls

Test first with a $20 kit before commissioning a system.
Route the pipe on the least visible elevation to skip cosmetic upgrades.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Great Falls FAQs

Get a Great Falls price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your MT ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Great Falls research

Best radon mitigation companies in Great Falls Radon Mitigation permits in Montana Radon Mitigation near me All Montana prices

More Montana cities

Billings Missoula Bozeman

Other project costs in Great Falls

Fence Installation in Great Falls

$1,485 – $3,960

Roof Replacement in Great Falls

$8,415 – $33,660

Kitchen Remodel in Great Falls

$17,820 – $94,050

HVAC Replacement in Great Falls

$5,445 – $17,820

Deck Building in Great Falls

$4,356 – $11,880

Window Replacement in Great Falls

$446 – $1,485

See every Great Falls cost guide