How much does radon mitigation cost in Greenville, SC?

Most Greenville homeowners spend between $875 – $2,450 on radon mitigation, with an average around $1,650. Local labor prices 3% below the national average, so Greenville quotes tend to land at the lower end of national ranges.

Why is radon mitigation more or less expensive in Greenville than elsewhere?

Licensed trade labor in Greenville runs about 97% of the national average, and the best crews book out fastest in spring and early summer. South Carolina weather drives material choices here, so ask contractors what they install most often in Greenville and why.

Do I need a permit for radon mitigation in Greenville, South Carolina?

Most Greenville, SC projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Greenville?

Get at least three written quotes from licensed, insured South Carolina contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Greenville metro market.

How much does radon mitigation cost in 2026?

Most homeowners pay between $900 and $2,500, with a national average near $1,700. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per system?

Installed pricing usually runs $900.00 to $2,500.00 per system, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-system price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Radon Mitigation/Greenville, SC

Greenville metro · South Carolina

Radon Mitigation cost in Greenville, SC

Greenville homeowners typically pay $875 – $2,450 for radon mitigation. Local labor and materials price 3% below the national average.

Get my Greenville estimate Use the Greenville calculator

Greenville average

$1,650

Typical low

$875

Typical high

$2,450

Per system

$875 – $2,450

Sample ZIP

What drives Greenville pricing

Local labor

Licensed trade labor in Greenville runs about 97% of the national average, and the best crews book out fastest in spring and early summer.

Permits & code

Most Greenville, SC projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not.

Climate & conditions

South Carolina weather drives material choices here, so ask contractors what they install most often in Greenville and why.

Instant cost calculator

Adjust the inputs to see live pricing

Number of suction points1 system

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$950 – $1,330

Most homeowners pay around $1,140

Compare quality / material level

Cost by material in Greenville

Installed Greenville pricing per system.

Option	Installed cost	Pros	Cons
Single-point sub-slab system	$1,000 – $1,400	—	—
Sub-slab with sealing	$1,400 – $1,850	—	—
Crawlspace membrane system	$1,850 – $2,400	—	—
Multi-point system with monitoring	$2,400 – $3,300	—	—

Where the money goes in Greenville

A typical $1,650 Greenville project, broken down by line item.

Labor0.45% · $7
Materials0.38% · $6
Permits & inspections0.05% · $1
Overhead & profit0.12% · $2

Common add-ons

Extras that show up on Greenville quotes but rarely in the headline price.

Post-mitigation testing

$145 – $290

Crawlspace vapor barrier

$1,450 – $4,850

Sump pit sealing

$195 – $775

Continuous radon monitor

$145 – $390

Ways to save in Greenville

Test first with a $20 kit before commissioning a system.
Route the pipe on the least visible elevation to skip cosmetic upgrades.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Greenville FAQs

Get a Greenville price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your SC ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Greenville research

Best radon mitigation companies in Greenville Radon Mitigation permits in South Carolina Radon Mitigation near me All South Carolina prices

More South Carolina cities

Charleston Columbia Myrtle Beach Rock Hill

Other project costs in Greenville

Fence Installation in Greenville

$1,455 – $3,880

Roof Replacement in Greenville

$8,245 – $32,980

Kitchen Remodel in Greenville

$17,460 – $92,150

HVAC Replacement in Greenville

$5,335 – $17,460

Deck Building in Greenville

$4,268 – $11,640

Window Replacement in Greenville

$437 – $1,455

See every Greenville cost guide