How much does sump pump installation cost in St. Paul, MN?

Most St. Paul homeowners spend between $635 – $2,650 on sump pump installation, with an average around $1,650. Local labor prices 6% above the national average, so St. Paul quotes tend to land at the higher end of national ranges.

Why is sump pump installation more or less expensive in St. Paul than elsewhere?

Licensed trade labor in St. Paul runs about 106% of the national average, and the best crews book out fastest in spring and early summer. Minnesota weather drives material choices here, so ask contractors what they install most often in St. Paul and why.

Do I need a permit for sump pump installation in St. Paul, Minnesota?

Most St. Paul, MN projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in St. Paul?

Get at least three written quotes from licensed, insured Minnesota contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the St. Paul metro market.

How much does sump pump installation cost in 2026?

Most homeowners pay between $600 and $2,500, with a national average near $1,550. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per unit?

Installed pricing usually runs $600.00 to $2,500.00 per unit, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-unit price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Sump Pump Installation/St. Paul, MN

St. Paul metro · Minnesota

Sump Pump Installation cost in St. Paul, MN

St. Paul homeowners typically pay $635 – $2,650 for sump pump installation. Local labor and materials price 6% above the national average.

Get my St. Paul estimate Use the St. Paul calculator

St. Paul average

$1,650

Typical low

$635

Typical high

$2,650

Per unit

$635 – $2,650

Sample ZIP

What drives St. Paul pricing

Local labor

Licensed trade labor in St. Paul runs about 106% of the national average, and the best crews book out fastest in spring and early summer.

Permits & code

Most St. Paul, MN projects that change structure, electrical, plumbing or mechanical systems need a permit from the local building department; cosmetic work usually does not.

Climate & conditions

Minnesota weather drives material choices here, so ask contractors what they install most often in St. Paul and why.

Instant cost calculator

Adjust the inputs to see live pricing

Number of pumps1 unit

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$950 – $1,330

Most homeowners pay around $1,140

Compare quality / material level

Cost by material in St. Paul

Installed St. Paul pricing per unit.

Option	Installed cost	Pros	Cons
1/3 HP pedestal	$1,000 – $1,400	—	—
1/2 HP submersible	$1,400 – $1,850	—	—
Submersible with battery backup	$1,850 – $2,400	—	—
Dual pump with water-powered backup	$2,400 – $3,300	—	—

Where the money goes in St. Paul

A typical $1,650 St. Paul project, broken down by line item.

Labor0.45% · $7
Materials0.38% · $6
Permits & inspections0.05% · $1
Overhead & profit0.12% · $2

Common add-ons

Extras that show up on St. Paul quotes but rarely in the headline price.

Battery backup system

$425 – $1,250

New sump pit excavation

$530 – $1,900

Discharge line extension

$160 – $635

Interior drain tile

$3,200 – $10,600

Ways to save in St. Paul

Install backup power — most failures happen during storm outages.
Replace preventively at year 8 instead of after a flood.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

St. Paul FAQs

Get a St. Paul price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your MN ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More St. Paul research

Best sump pump installation companies in St. Paul Sump Pump Installation permits in Minnesota Sump Pump Installation near me All Minnesota prices

More Minnesota cities

Minneapolis Rochester Duluth Bloomington Plymouth

Other project costs in St. Paul

Fence Installation in St. Paul

$1,590 – $4,240

Roof Replacement in St. Paul

$9,010 – $36,040

Kitchen Remodel in St. Paul

$19,080 – $100,700

HVAC Replacement in St. Paul

$5,830 – $19,080

Deck Building in St. Paul

$4,664 – $12,720

Window Replacement in St. Paul

$477 – $1,590

See every St. Paul cost guide