How much does drywall installation cost in Dallas, TX?

Most Dallas homeowners spend between $1,550 – $3,550 on drywall installation, with an average around $2,550. Local labor prices 2% above the national average, so Dallas quotes tend to land at the higher end of national ranges.

Why is drywall installation more or less expensive in Dallas than elsewhere?

DFW has deep contractor supply, so bids stay close to the national average outside storm season. Hail and high winds drive frequent roof replacement and impact-rated material upgrades.

Do I need a permit for drywall installation in Dallas, Texas?

Dallas permits are required for roofing, structural, electrical and fences over 6 feet. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Dallas?

Get at least three written quotes from licensed, insured Texas contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Dallas-Fort Worth market.

How much does drywall installation cost in 2026?

Most homeowners pay between $1,500 and $3,500, with a national average near $2,500. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per square foot?

Installed pricing usually runs $1.50 to $3.50 per square foot, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-square foot price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Drywall Installation/Dallas, TX

Dallas-Fort Worth · Texas

Drywall Installation cost in Dallas, TX

Dallas homeowners typically pay $1,550 – $3,550 for drywall installation. Local labor and materials price 2% above the national average.

Get my Dallas estimate Use the Dallas calculator

Dallas average

$2,550

Typical low

$1,550

Typical high

$3,550

Per square foot

$2 – $4

Sample ZIP

75201

What drives Dallas pricing

Local labor

DFW has deep contractor supply, so bids stay close to the national average outside storm season.

Permits & code

Dallas permits are required for roofing, structural, electrical and fences over 6 feet.

Climate & conditions

Hail and high winds drive frequent roof replacement and impact-rated material upgrades.

Instant cost calculator

Adjust the inputs to see live pricing

Drywall area (sq ft)1,000 square feet

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$1,501 – $2,062

Most homeowners pay around $1,781

Compare quality / material level

Cost by material in Dallas

Installed Dallas pricing per square foot.

Option	Installed cost	Pros	Cons
Hang only	$2 – $2	—	—
Hang, tape and finish (Level 4)	$2 – $3	—	—
Level 5 smooth finish	$3 – $4	—	—
Moisture / fire-rated assemblies	$4 – $5	—	—

Where the money goes in Dallas

A typical $2,550 Dallas project, broken down by line item.

Labor0.45% · $11
Materials0.38% · $10
Permits & inspections0.05% · $1
Overhead & profit0.12% · $3

Common add-ons

Extras that show up on Dallas quotes but rarely in the headline price.

Ceiling texture removal

$510 – $2,550

Insulation before board

$410 – $2,050

Corner bead and archways

$155 – $815

Painting after finish

$510 – $2,550

Ways to save in Dallas

Order board delivered to the room to avoid carry charges.
Accept a Level 4 finish unless walls take raking light.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Dallas FAQs

Get a Dallas price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your TX ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Dallas research

Best drywall installation companies in Dallas Drywall Installation permits in Texas Drywall Installation near me All Texas prices

Drywall Installation cost near Dallas

Drywall Installation cost in Fort Worth, TX

$1,520 – $3,480

Drywall Installation cost in Plano, TX

$1,596 – $3,654

Drywall Installation cost in Frisco, TX

$1,611 – $3,689

Drywall Installation cost in Arlington, TX

$1,504 – $3,446

Drywall Installation cost in Irving, TX

$1,520 – $3,480

Drywall Installation cost in McKinney, TX

$1,580 – $3,620

More Texas cities

Denton Garland Houston Katy Sugar Land The Woodlands Pearland Pasadena

Other project costs in Dallas

Fence Installation in Dallas

$1,530 – $4,080

Roof Replacement in Dallas

$8,670 – $34,680

Kitchen Remodel in Dallas

$18,360 – $96,900

HVAC Replacement in Dallas

$5,610 – $18,360

Deck Building in Dallas

$4,488 – $12,240

Window Replacement in Dallas

$459 – $1,530

See every Dallas cost guide