How much does electrical panel upgrade cost in Irving, TX?

Most Irving homeowners spend between $1,800 – $4,500 on electrical panel upgrade, with an average around $2,900. Local labor prices right at the national average, so Irving quotes tend to land at the higher end of national ranges.

Why is electrical panel upgrade more or less expensive in Irving than elsewhere?

Irving quotes track the DFW average closely. Hail and wind events drive periodic roof replacement.

Do I need a permit for electrical panel upgrade in Irving, Texas?

City permits apply to most exterior and mechanical work. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Irving?

Get at least three written quotes from licensed, insured Texas contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Dallas-Fort Worth market.

How much does a 200 amp panel upgrade cost?

$2,000 to $4,500 typically, or $2,800 to $6,000 if the meter base and service entrance also need replacing.

How long does a panel upgrade take?

One day for the electrical work, with power out four to eight hours. Utility scheduling and inspection may spread it over a few days.

Do I need 200 amps for an EV charger?

Usually. A Level 2 charger draws 40 to 60 amps; most 100 amp services cannot support it without load management.

Is a permit required?

Always. The utility will not reconnect without an inspection sign-off, and unpermitted work surfaces during a home sale.

What are Federal Pacific and Zinsco panels?

Obsolete panels with breakers that fail to trip. Insurers often refuse coverage and replacement is strongly recommended regardless of capacity.

Can I just add a subpanel instead?

A subpanel adds circuit space, not capacity. If your total service is maxed out, you still need the main upgrade.

Home/Cost guides/Electrical Panel Upgrade/Irving, TX

Dallas-Fort Worth · Texas

Electrical Panel Upgrade cost in Irving, TX

Irving homeowners typically pay $1,800 – $4,500 for electrical panel upgrade. Local labor and materials price right at the national average.

Get my Irving estimate Use the Irving calculator

Irving average

$2,900

Typical low

$1,800

Typical high

$4,500

Per panel

$1,300 – $6,000

Sample ZIP

75038

What drives Irving pricing

Local labor

Irving quotes track the DFW average closely.

Permits & code

City permits apply to most exterior and mechanical work.

Climate & conditions

Hail and wind events drive periodic roof replacement.

Instant cost calculator

Adjust the inputs to see live pricing

Panels to upgrade1 panel

Target service size

Service entrance

Panel location

Code corrections

Estimated project cost

$1,300 – $2,500

Most homeowners pay around $1,900

Compare target service size

Cost by material in Irving

Installed Irving pricing per panel.

Option	Installed cost	Pros	Cons
100 amp service	$1,300 – $2,500	Fine for small homes with gas heat	No headroom for EV or heat pump
150 amp service	$1,800 – $3,200	Middle ground	Often costs nearly the same as 200
200 amp service	$2,000 – $4,500	The modern standard, supports EV and electrification	May require new meter base
400 amp service	$4,000 – $9,000	Large homes, shops, multiple EVs	Utility coordination and two panels
Subpanel	$600 – $2,000	Cheap way to add circuits	Does not increase total service capacity

Where the money goes in Irving

A typical $2,900 Irving project, broken down by line item.

Labor48% · $1,392
Panel and breakers27% · $783
Service entrance materials15% · $435
Permits and inspection10% · $290

Common add-ons

Extras that show up on Irving quotes but rarely in the headline price.

EV charger circuit

$500 – $2,000

Whole-home surge protector

$250 – $700

Generator interlock or transfer switch

$400 – $2,500

Grounding rod system update

$200 – $800

AFCI/GFCI breaker upgrades

Per breaker

$40 – $120

Ways to save in Irving

Go straight to 200 amp — the incremental cost over 150 is small and you will not repeat the job.
Bundle EV charger, surge protector and any new circuits into the same permit and visit.
Check for utility and federal electrification rebates before you sign.
Get three bids; panel pricing varies more between electricians than almost any other trade.
Ask about keeping the panel in its existing location to avoid relocation cost.

Irving FAQs

Get a Irving price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your TX ZIP code — then connect you with vetted local pros.

Get electrician quotes

More Irving research

Best electrical panel upgrade companies in Irving Electrical Panel Upgrade permits in Texas Electrical Panel Upgrade near me All Texas prices

Electrical Panel Upgrade cost near Irving

Electrical Panel Upgrade cost in Dallas, TX

$1,836 – $4,590

Electrical Panel Upgrade cost in Fort Worth, TX

$1,800 – $4,500

Electrical Panel Upgrade cost in Plano, TX

$1,890 – $4,725

Electrical Panel Upgrade cost in Frisco, TX

$1,908 – $4,770

Electrical Panel Upgrade cost in Arlington, TX

$1,782 – $4,455

Electrical Panel Upgrade cost in McKinney, TX

$1,872 – $4,680

More Texas cities

Denton Garland Houston Katy Sugar Land The Woodlands Pearland Pasadena

Other project costs in Irving

Fence Installation in Irving

$1,500 – $4,000

Roof Replacement in Irving

$8,500 – $34,000

Kitchen Remodel in Irving

$18,000 – $95,000

HVAC Replacement in Irving

$5,500 – $18,000

Deck Building in Irving

$4,400 – $12,000

Window Replacement in Irving

$450 – $1,500

See every Irving cost guide