How much does electrical panel upgrade cost in San Antonio, TX?

Most San Antonio homeowners spend between $1,750 – $4,300 on electrical panel upgrade, with an average around $2,800. Local labor prices 4% below the national average, so San Antonio quotes tend to land at the lower end of national ranges.

Why is electrical panel upgrade more or less expensive in San Antonio than elsewhere?

San Antonio is the most affordable large Texas market for licensed trades. Heat and expansive soils drive HVAC and foundation spend.

Do I need a permit for electrical panel upgrade in San Antonio, Texas?

City permits required for roofing, structural and mechanical work. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in San Antonio?

Get at least three written quotes from licensed, insured Texas contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the San Antonio market.

How much does a 200 amp panel upgrade cost?

$2,000 to $4,500 typically, or $2,800 to $6,000 if the meter base and service entrance also need replacing.

How long does a panel upgrade take?

One day for the electrical work, with power out four to eight hours. Utility scheduling and inspection may spread it over a few days.

Do I need 200 amps for an EV charger?

Usually. A Level 2 charger draws 40 to 60 amps; most 100 amp services cannot support it without load management.

Is a permit required?

Always. The utility will not reconnect without an inspection sign-off, and unpermitted work surfaces during a home sale.

What are Federal Pacific and Zinsco panels?

Obsolete panels with breakers that fail to trip. Insurers often refuse coverage and replacement is strongly recommended regardless of capacity.

Can I just add a subpanel instead?

A subpanel adds circuit space, not capacity. If your total service is maxed out, you still need the main upgrade.

Home/Cost guides/Electrical Panel Upgrade/San Antonio, TX

San Antonio · Texas

Electrical Panel Upgrade cost in San Antonio, TX

San Antonio homeowners typically pay $1,750 – $4,300 for electrical panel upgrade. Local labor and materials price 4% below the national average.

Get my San Antonio estimate Use the San Antonio calculator

San Antonio average

$2,800

Typical low

$1,750

Typical high

$4,300

Per panel

$1,250 – $5,750

Sample ZIP

78205

What drives San Antonio pricing

Local labor

San Antonio is the most affordable large Texas market for licensed trades.

Permits & code

City permits required for roofing, structural and mechanical work.

Climate & conditions

Heat and expansive soils drive HVAC and foundation spend.

Instant cost calculator

Adjust the inputs to see live pricing

Panels to upgrade1 panel

Target service size

Service entrance

Panel location

Code corrections

Estimated project cost

$1,250 – $2,400

Most homeowners pay around $1,825

Compare target service size

Cost by material in San Antonio

Installed San Antonio pricing per panel.

Option	Installed cost	Pros	Cons
100 amp service	$1,250 – $2,400	Fine for small homes with gas heat	No headroom for EV or heat pump
150 amp service	$1,750 – $3,050	Middle ground	Often costs nearly the same as 200
200 amp service	$1,900 – $4,300	The modern standard, supports EV and electrification	May require new meter base
400 amp service	$3,850 – $8,650	Large homes, shops, multiple EVs	Utility coordination and two panels
Subpanel	$575 – $1,900	Cheap way to add circuits	Does not increase total service capacity

Where the money goes in San Antonio

A typical $2,800 San Antonio project, broken down by line item.

Labor48% · $1,344
Panel and breakers27% · $756
Service entrance materials15% · $420
Permits and inspection10% · $280

Common add-ons

Extras that show up on San Antonio quotes but rarely in the headline price.

EV charger circuit

$480 – $1,900

Whole-home surge protector

$240 – $670

Generator interlock or transfer switch

$385 – $2,400

Grounding rod system update

$190 – $770

AFCI/GFCI breaker upgrades

Per breaker

$38 – $115

Ways to save in San Antonio

Go straight to 200 amp — the incremental cost over 150 is small and you will not repeat the job.
Bundle EV charger, surge protector and any new circuits into the same permit and visit.
Check for utility and federal electrification rebates before you sign.
Get three bids; panel pricing varies more between electricians than almost any other trade.
Ask about keeping the panel in its existing location to avoid relocation cost.

San Antonio FAQs

Get a San Antonio price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your TX ZIP code — then connect you with vetted local pros.

Get electrician quotes