How much does water heater installation cost in Irving, TX?

Most Irving homeowners spend between $1,200 – $3,500 on water heater installation, with an average around $2,100. Local labor prices right at the national average, so Irving quotes tend to land at the higher end of national ranges.

Why is water heater installation more or less expensive in Irving than elsewhere?

Irving quotes track the DFW average closely. Hail and wind events drive periodic roof replacement.

Do I need a permit for water heater installation in Irving, Texas?

City permits apply to most exterior and mechanical work. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Irving?

Get at least three written quotes from licensed, insured Texas contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Dallas-Fort Worth market.

How much does it cost to replace a water heater?

$1,200 to $3,500 installed. A straight 50-gallon tank swap is $1,200 to $2,400; tankless conversion is $3,000 to $6,500.

Is tankless worth it?

If you plan to stay 10+ years, yes. It costs two to three times more to install but lasts twice as long and cuts water heating energy 20% to 30%.

How long does a water heater last?

Eight to twelve years for a gas tank, ten to fifteen for electric, and twenty or more for tankless with annual descaling.

What size water heater do I need?

40 gallons for two to three people, 50 for three to four, 75 to 80 for five or more. First-hour rating matters more than raw capacity.

Is a heat pump water heater a good idea?

In a garage or basement with adequate space and a mild climate, it cuts water heating cost 60% to 70% and often qualifies for large rebates.

Most jurisdictions require one, especially for gas and venting changes. Unpermitted work can surface at resale.

Home/Cost guides/Water Heater Installation/Irving, TX

Dallas-Fort Worth · Texas

Water Heater Installation cost in Irving, TX

Irving homeowners typically pay $1,200 – $3,500 for water heater installation. Local labor and materials price right at the national average.

Get my Irving estimate Use the Irving calculator

Irving average

$2,100

Typical low

$1,200

Typical high

$3,500

Per unit

$900 – $6,500

Sample ZIP

75038

What drives Irving pricing

Local labor

Irving quotes track the DFW average closely.

Permits & code

City permits apply to most exterior and mechanical work.

Climate & conditions

Hail and wind events drive periodic roof replacement.

Instant cost calculator

Adjust the inputs to see live pricing

Units1 unit

Water heater type

Fuel or type change

Location

Estimated project cost

$1,000 – $2,500

Most homeowners pay around $1,750

Compare water heater type

Cost by material in Irving

Installed Irving pricing per unit.

Option	Installed cost	Pros	Cons
Gas tank	$1,000 – $2,500	Fast recovery, cheap to run	Needs venting, 8-12 year life
Electric tank	$900 – $2,200	Cheapest install, no venting	Slower recovery, higher operating cost
Gas tankless	$2,500 – $6,000	Endless hot water, 20+ year life, saves space	Costly install, may need larger gas line
Electric tankless	$1,500 – $4,000	Compact, point-of-use friendly	Big amperage draw, struggles in cold climates
Heat pump (hybrid)	$2,200 – $5,500	Cuts water heating energy 60-70%, rebate eligible	Needs conditioned space and clearance
Solar water heater	$3,500 – $9,000	Lowest operating cost	Backup unit still required

Where the money goes in Irving

A typical $2,100 Irving project, broken down by line item.

Water heater unit48% · $1,008
Labor32% · $672
Venting, gas or electrical12% · $252
Permit, disposal and fittings8% · $168

Common add-ons

Extras that show up on Irving quotes but rarely in the headline price.

Expansion tank

$100 – $350

New gas line or upsizing

$300 – $1,200

Dedicated 240V circuit

$400 – $1,200

Venting modification

$300 – $1,500

Drain pan and leak sensor

$100 – $400

Water softener

$800 – $3,000

Ways to save in Irving

Replace before it fails so you are not paying emergency rates.
Right-size the tank; oversizing wastes standby energy every day for a decade.
Check federal, state and utility rebates for heat pump water heaters — they can cover $500 to $2,000.
Stay with your existing fuel type unless energy math clearly favors switching.
Buy the unit yourself during a sale and pay only for installation labor.

Irving FAQs

Get a Irving price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your TX ZIP code — then connect you with vetted local pros.

Get water heater quotes

More Irving research

Best water heater installation companies in Irving Water Heater Installation permits in Texas Water Heater Installation near me All Texas prices

Water Heater Installation cost near Irving

Water Heater Installation cost in Dallas, TX

$1,224 – $3,570

Water Heater Installation cost in Fort Worth, TX

$1,200 – $3,500

Water Heater Installation cost in Plano, TX

$1,260 – $3,675

Water Heater Installation cost in Frisco, TX

$1,272 – $3,710

Water Heater Installation cost in Arlington, TX

$1,188 – $3,465

Water Heater Installation cost in McKinney, TX

$1,248 – $3,640

More Texas cities

Denton Garland Houston Katy Sugar Land The Woodlands Pearland Pasadena

Other project costs in Irving

Fence Installation in Irving

$1,500 – $4,000

Roof Replacement in Irving

$8,500 – $34,000

Kitchen Remodel in Irving

$18,000 – $95,000

HVAC Replacement in Irving

$5,500 – $18,000

Deck Building in Irving

$4,400 – $12,000

Window Replacement in Irving

$450 – $1,500

See every Irving cost guide