How much does ductwork replacement cost in Seattle, WA?

Most Seattle homeowners spend between $4,800 – $11,500 on ductwork replacement, with an average around $8,150. Local labor prices 28% above the national average, so Seattle quotes tend to land at the higher end of national ranges.

Why is ductwork replacement more or less expensive in Seattle than elsewhere?

Seattle trade labor is among the most expensive in the country and books months ahead. Persistent rain demands drainage detailing, flashing and rot-resistant materials.

Do I need a permit for ductwork replacement in Seattle, Washington?

SDCI permits and inspections are required for most exterior and structural work. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Seattle?

Get at least three written quotes from licensed, insured Washington contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Seattle market.

How much does ductwork replacement cost in 2026?

Most homeowners pay between $3,750 and $9,000, with a national average near $6,375. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per linear foot?

Installed pricing usually runs $25.00 to $60.00 per linear foot, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-linear foot price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Ductwork Replacement/Seattle, WA

Seattle · Washington

Ductwork Replacement cost in Seattle, WA

Seattle homeowners typically pay $4,800 – $11,500 for ductwork replacement. Local labor and materials price 28% above the national average.

Get my Seattle estimate Use the Seattle calculator

Seattle average

$8,150

Typical low

$4,800

Typical high

$11,500

Per linear foot

$32 – $77

Sample ZIP

98101

What drives Seattle pricing

Local labor

Seattle trade labor is among the most expensive in the country and books months ahead.

Permits & code

SDCI permits and inspections are required for most exterior and structural work.

Climate & conditions

Persistent rain demands drainage detailing, flashing and rot-resistant materials.

Instant cost calculator

Adjust the inputs to see live pricing

Duct run (linear feet)150 linear feet

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$4,845 – $6,555

Most homeowners pay around $5,700

Compare quality / material level

Cost by material in Seattle

Installed Seattle pricing per linear foot.

Option	Installed cost	Pros	Cons
Flexible duct	$34 – $46	—	—
Sheet metal trunk and flex runs	$46 – $61	—	—
Insulated sheet metal	$61 – $79	—	—
Custom sealed metal with zoning	$79 – $110	—	—

Where the money goes in Seattle

A typical $8,150 Seattle project, broken down by line item.

Labor0.45% · $37
Materials0.38% · $31
Permits & inspections0.05% · $4
Overhead & profit0.12% · $10

Common add-ons

Extras that show up on Seattle quotes but rarely in the headline price.

Duct sealing (Aeroseal)

$1,300 – $3,850

New returns

$385 – $1,550

Zoning dampers

$1,900 – $5,750

Asbestos duct wrap removal

$1,300 – $6,400

Ways to save in Seattle

Replace ducts while the system is being replaced — one mobilization.
Seal instead of replace when ducts are intact but leaky.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Seattle FAQs

Get a Seattle price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your WA ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Seattle research

Best ductwork replacement companies in Seattle Ductwork Replacement permits in Washington Ductwork Replacement near me All Washington prices

Ductwork Replacement cost near Seattle

Ductwork Replacement cost in Bellevue, WA

$4,950 – $11,859

Ductwork Replacement cost in Tacoma, WA

$4,313 – $10,332

Ductwork Replacement cost in Everett, WA

$4,425 – $10,602

Ductwork Replacement cost in Kent, WA

$4,463 – $10,691

Ductwork Replacement cost in Renton, WA

$4,500 – $10,781

More Washington cities

Spokane Vancouver Olympia

Other project costs in Seattle

Fence Installation in Seattle

$1,920 – $5,120

Roof Replacement in Seattle

$10,880 – $43,520

Kitchen Remodel in Seattle

$23,040 – $121,600

HVAC Replacement in Seattle

$7,040 – $23,040

Deck Building in Seattle

$5,632 – $15,360

Window Replacement in Seattle

$576 – $1,920

See every Seattle cost guide