How much does ductwork replacement cost in Tacoma, WA?

Most Tacoma homeowners spend between $4,300 – $10,400 on ductwork replacement, with an average around $7,350. Local labor prices 15% above the national average, so Tacoma quotes tend to land at the higher end of national ranges.

Why is ductwork replacement more or less expensive in Tacoma than elsewhere?

Tacoma prices meaningfully below Seattle with better availability. Rain and moss growth shorten roof service life.

Do I need a permit for ductwork replacement in Tacoma, Washington?

City permits required for structural, roofing and mechanical work. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Tacoma?

Get at least three written quotes from licensed, insured Washington contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Seattle market.

How much does ductwork replacement cost in 2026?

Most homeowners pay between $3,750 and $9,000, with a national average near $6,375. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per linear foot?

Installed pricing usually runs $25.00 to $60.00 per linear foot, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-linear foot price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Ductwork Replacement/Tacoma, WA

Seattle · Washington

Ductwork Replacement cost in Tacoma, WA

Tacoma homeowners typically pay $4,300 – $10,400 for ductwork replacement. Local labor and materials price 15% above the national average.

Get my Tacoma estimate Use the Tacoma calculator

Tacoma average

$7,350

Typical low

$4,300

Typical high

$10,400

Per linear foot

$29 – $69

Sample ZIP

98402

What drives Tacoma pricing

Local labor

Tacoma prices meaningfully below Seattle with better availability.

Permits & code

City permits required for structural, roofing and mechanical work.

Climate & conditions

Rain and moss growth shorten roof service life.

Instant cost calculator

Adjust the inputs to see live pricing

Duct run (linear feet)150 linear feet

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$4,275 – $5,985

Most homeowners pay around $5,130

Compare quality / material level

Cost by material in Tacoma

Installed Tacoma pricing per linear foot.

Option	Installed cost	Pros	Cons
Flexible duct	$30 – $42	—	—
Sheet metal trunk and flex runs	$42 – $55	—	—
Insulated sheet metal	$55 – $71	—	—
Custom sealed metal with zoning	$71 – $98	—	—

Where the money goes in Tacoma

A typical $7,350 Tacoma project, broken down by line item.

Labor0.45% · $33
Materials0.38% · $28
Permits & inspections0.05% · $4
Overhead & profit0.12% · $9

Common add-ons

Extras that show up on Tacoma quotes but rarely in the headline price.

Duct sealing (Aeroseal)

$1,150 – $3,450

New returns

$345 – $1,400

Zoning dampers

$1,700 – $5,200

Asbestos duct wrap removal

$1,150 – $5,750

Ways to save in Tacoma

Replace ducts while the system is being replaced — one mobilization.
Seal instead of replace when ducts are intact but leaky.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Tacoma FAQs

Get a Tacoma price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your WA ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Tacoma research

Best ductwork replacement companies in Tacoma Ductwork Replacement permits in Washington Ductwork Replacement near me All Washington prices

Ductwork Replacement cost near Tacoma

Ductwork Replacement cost in Seattle, WA

$4,786 – $11,576

Ductwork Replacement cost in Bellevue, WA

$4,936 – $11,937

Ductwork Replacement cost in Everett, WA

$4,412 – $10,671

Ductwork Replacement cost in Kent, WA

$4,450 – $10,762

Ductwork Replacement cost in Renton, WA

$4,487 – $10,852

More Washington cities

Spokane Vancouver Olympia

Other project costs in Tacoma

Fence Installation in Tacoma

$1,725 – $4,600

Roof Replacement in Tacoma

$9,775 – $39,100

Kitchen Remodel in Tacoma

$20,700 – $109,250

HVAC Replacement in Tacoma

$6,325 – $20,700

Deck Building in Tacoma

$5,060 – $13,800

Window Replacement in Tacoma

$518 – $1,725

See every Tacoma cost guide