How much does electrical panel upgrade cost in Cedar Park, TX?

Most Cedar Park homeowners spend between $1,950 – $4,900 on electrical panel upgrade, with an average around $3,150. Local labor prices 9% above the national average, so Cedar Park quotes tend to land at the higher end of national ranges.

Why is electrical panel upgrade more or less expensive in Cedar Park than elsewhere?

Northwest Austin suburb with premium finish expectations. Limestone substrate increases digging and drilling costs.

Do I need a permit for electrical panel upgrade in Cedar Park, Texas?

City permits required for structural and exterior work. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Cedar Park?

Get at least three written quotes from licensed, insured Texas contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Austin market.

How much does a 200 amp panel upgrade cost?

$2,000 to $4,500 typically, or $2,800 to $6,000 if the meter base and service entrance also need replacing.

How long does a panel upgrade take?

One day for the electrical work, with power out four to eight hours. Utility scheduling and inspection may spread it over a few days.

Do I need 200 amps for an EV charger?

Usually. A Level 2 charger draws 40 to 60 amps; most 100 amp services cannot support it without load management.

Is a permit required?

Always. The utility will not reconnect without an inspection sign-off, and unpermitted work surfaces during a home sale.

What are Federal Pacific and Zinsco panels?

Obsolete panels with breakers that fail to trip. Insurers often refuse coverage and replacement is strongly recommended regardless of capacity.

Can I just add a subpanel instead?

A subpanel adds circuit space, not capacity. If your total service is maxed out, you still need the main upgrade.

Home/Cost guides/Electrical Panel Upgrade/Cedar Park, TX

Austin · Texas

Electrical Panel Upgrade cost in Cedar Park, TX

Cedar Park homeowners typically pay $1,950 – $4,900 for electrical panel upgrade. Local labor and materials price 9% above the national average.

Get my Cedar Park estimate Use the Cedar Park calculator

Cedar Park average

$3,150

Typical low

$1,950

Typical high

$4,900

Per panel

$1,400 – $6,550

Sample ZIP

78613

What drives Cedar Park pricing

Local labor

Northwest Austin suburb with premium finish expectations.

Permits & code

City permits required for structural and exterior work.

Climate & conditions

Limestone substrate increases digging and drilling costs.

Instant cost calculator

Adjust the inputs to see live pricing

Panels to upgrade1 panel

Target service size

Service entrance

Panel location

Code corrections

Estimated project cost

$1,400 – $2,750

Most homeowners pay around $2,075

Compare target service size

Cost by material in Cedar Park

Installed Cedar Park pricing per panel.

Option	Installed cost	Pros	Cons
100 amp service	$1,400 – $2,750	Fine for small homes with gas heat	No headroom for EV or heat pump
150 amp service	$1,950 – $3,500	Middle ground	Often costs nearly the same as 200
200 amp service	$2,200 – $4,900	The modern standard, supports EV and electrification	May require new meter base
400 amp service	$4,350 – $9,800	Large homes, shops, multiple EVs	Utility coordination and two panels
Subpanel	$655 – $2,200	Cheap way to add circuits	Does not increase total service capacity

Where the money goes in Cedar Park

A typical $3,150 Cedar Park project, broken down by line item.

Labor48% · $1,512
Panel and breakers27% · $851
Service entrance materials15% · $473
Permits and inspection10% · $315

Common add-ons

Extras that show up on Cedar Park quotes but rarely in the headline price.

EV charger circuit

$545 – $2,200

Whole-home surge protector

$275 – $765

Generator interlock or transfer switch

$435 – $2,750

Grounding rod system update

$220 – $870

AFCI/GFCI breaker upgrades

Per breaker

$44 – $130

Ways to save in Cedar Park

Go straight to 200 amp — the incremental cost over 150 is small and you will not repeat the job.
Bundle EV charger, surge protector and any new circuits into the same permit and visit.
Check for utility and federal electrification rebates before you sign.
Get three bids; panel pricing varies more between electricians than almost any other trade.
Ask about keeping the panel in its existing location to avoid relocation cost.

Cedar Park FAQs

Get a Cedar Park price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your TX ZIP code — then connect you with vetted local pros.

Get electrician quotes

More Cedar Park research

Best electrical panel upgrade companies in Cedar Park Electrical Panel Upgrade permits in Texas Electrical Panel Upgrade near me All Texas prices

Electrical Panel Upgrade cost near Cedar Park

Electrical Panel Upgrade cost in Austin, TX

$2,004 – $5,035

Electrical Panel Upgrade cost in Round Rock, TX

$1,932 – $4,855

Electrical Panel Upgrade cost in Georgetown, TX

$1,896 – $4,765

Electrical Panel Upgrade cost in San Marcos, TX

$1,861 – $4,675

Electrical Panel Upgrade cost in Pflugerville, TX

$1,914 – $4,810

More Texas cities

Dallas Fort Worth Plano Frisco Arlington Irving McKinney Denton

Other project costs in Cedar Park

Fence Installation in Cedar Park

$1,635 – $4,360

Roof Replacement in Cedar Park

$9,265 – $37,060

Kitchen Remodel in Cedar Park

$19,620 – $103,550

HVAC Replacement in Cedar Park

$5,995 – $19,620

Deck Building in Cedar Park

$4,796 – $13,080

Window Replacement in Cedar Park

$491 – $1,635

See every Cedar Park cost guide