How much does electrical panel upgrade cost in Georgetown, TX?

Most Georgetown homeowners spend between $1,900 – $4,750 on electrical panel upgrade, with an average around $3,050. Local labor prices 6% above the national average, so Georgetown quotes tend to land at the higher end of national ranges.

Why is electrical panel upgrade more or less expensive in Georgetown than elsewhere?

Georgetown crews price slightly under the Austin core. Hill Country rock and heat affect excavation and HVAC.

Do I need a permit for electrical panel upgrade in Georgetown, Texas?

City permits and historic district review in the downtown area. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Georgetown?

Get at least three written quotes from licensed, insured Texas contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Austin market.

How much does a 200 amp panel upgrade cost?

$2,000 to $4,500 typically, or $2,800 to $6,000 if the meter base and service entrance also need replacing.

How long does a panel upgrade take?

One day for the electrical work, with power out four to eight hours. Utility scheduling and inspection may spread it over a few days.

Do I need 200 amps for an EV charger?

Usually. A Level 2 charger draws 40 to 60 amps; most 100 amp services cannot support it without load management.

Is a permit required?

Always. The utility will not reconnect without an inspection sign-off, and unpermitted work surfaces during a home sale.

What are Federal Pacific and Zinsco panels?

Obsolete panels with breakers that fail to trip. Insurers often refuse coverage and replacement is strongly recommended regardless of capacity.

Can I just add a subpanel instead?

A subpanel adds circuit space, not capacity. If your total service is maxed out, you still need the main upgrade.

Home/Cost guides/Electrical Panel Upgrade/Georgetown, TX

Austin · Texas

Electrical Panel Upgrade cost in Georgetown, TX

Georgetown homeowners typically pay $1,900 – $4,750 for electrical panel upgrade. Local labor and materials price 6% above the national average.

Get my Georgetown estimate Use the Georgetown calculator

Georgetown average

$3,050

Typical low

$1,900

Typical high

$4,750

Per panel

$1,400 – $6,350

Sample ZIP

78626

What drives Georgetown pricing

Local labor

Georgetown crews price slightly under the Austin core.

Permits & code

City permits and historic district review in the downtown area.

Climate & conditions

Hill Country rock and heat affect excavation and HVAC.

Instant cost calculator

Adjust the inputs to see live pricing

Panels to upgrade1 panel

Target service size

Service entrance

Panel location

Code corrections

Estimated project cost

$1,400 – $2,650

Most homeowners pay around $2,025

Compare target service size

Cost by material in Georgetown

Installed Georgetown pricing per panel.

Option	Installed cost	Pros	Cons
100 amp service	$1,400 – $2,650	Fine for small homes with gas heat	No headroom for EV or heat pump
150 amp service	$1,900 – $3,400	Middle ground	Often costs nearly the same as 200
200 amp service	$2,100 – $4,750	The modern standard, supports EV and electrification	May require new meter base
400 amp service	$4,250 – $9,550	Large homes, shops, multiple EVs	Utility coordination and two panels
Subpanel	$635 – $2,100	Cheap way to add circuits	Does not increase total service capacity

Where the money goes in Georgetown

A typical $3,050 Georgetown project, broken down by line item.

Labor48% · $1,464
Panel and breakers27% · $824
Service entrance materials15% · $458
Permits and inspection10% · $305

Common add-ons

Extras that show up on Georgetown quotes but rarely in the headline price.

EV charger circuit

$530 – $2,100

Whole-home surge protector

$265 – $740

Generator interlock or transfer switch

$425 – $2,650

Grounding rod system update

$210 – $850

AFCI/GFCI breaker upgrades

Per breaker

$42 – $125

Ways to save in Georgetown

Go straight to 200 amp — the incremental cost over 150 is small and you will not repeat the job.
Bundle EV charger, surge protector and any new circuits into the same permit and visit.
Check for utility and federal electrification rebates before you sign.
Get three bids; panel pricing varies more between electricians than almost any other trade.
Ask about keeping the panel in its existing location to avoid relocation cost.

Georgetown FAQs

Get a Georgetown price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your TX ZIP code — then connect you with vetted local pros.

Get electrician quotes

More Georgetown research

Best electrical panel upgrade companies in Georgetown Electrical Panel Upgrade permits in Texas Electrical Panel Upgrade near me All Texas prices

Electrical Panel Upgrade cost near Georgetown

Electrical Panel Upgrade cost in Austin, TX

$2,008 – $5,019

Electrical Panel Upgrade cost in Round Rock, TX

$1,936 – $4,840

Electrical Panel Upgrade cost in Cedar Park, TX

$1,954 – $4,884

Electrical Panel Upgrade cost in San Marcos, TX

$1,864 – $4,660

Electrical Panel Upgrade cost in Pflugerville, TX

$1,918 – $4,795

More Texas cities

Dallas Fort Worth Plano Frisco Arlington Irving McKinney Denton

Other project costs in Georgetown

Fence Installation in Georgetown

$1,590 – $4,240

Roof Replacement in Georgetown

$9,010 – $36,040

Kitchen Remodel in Georgetown

$19,080 – $100,700

HVAC Replacement in Georgetown

$5,830 – $19,080

Deck Building in Georgetown

$4,664 – $12,720

Window Replacement in Georgetown

$477 – $1,590

See every Georgetown cost guide