How much does sump pump installation cost in Denton, TX?

Most Denton homeowners spend between $590 – $2,450 on sump pump installation, with an average around $1,500. Local labor prices 2% below the national average, so Denton quotes tend to land at the lower end of national ranges.

Why is sump pump installation more or less expensive in Denton than elsewhere?

Denton labor prices under the DFW core. Expansive clay soils make foundation work a common line item.

Do I need a permit for sump pump installation in Denton, Texas?

City permits required for structural and exterior projects. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Denton?

Get at least three written quotes from licensed, insured Texas contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Dallas-Fort Worth market.

How much does sump pump installation cost in 2026?

Most homeowners pay between $600 and $2,500, with a national average near $1,550. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per unit?

Installed pricing usually runs $600.00 to $2,500.00 per unit, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-unit price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Sump Pump Installation/Denton, TX

Dallas-Fort Worth · Texas

Sump Pump Installation cost in Denton, TX

Denton homeowners typically pay $590 – $2,450 for sump pump installation. Local labor and materials price 2% below the national average.

Get my Denton estimate Use the Denton calculator

Denton average

$1,500

Typical low

$590

Typical high

$2,450

Per unit

$590 – $2,450

Sample ZIP

76201

What drives Denton pricing

Local labor

Denton labor prices under the DFW core.

Permits & code

City permits required for structural and exterior projects.

Climate & conditions

Expansive clay soils make foundation work a common line item.

Instant cost calculator

Adjust the inputs to see live pricing

Number of pumps1 unit

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$893 – $1,235

Most homeowners pay around $1,064

Compare quality / material level

Cost by material in Denton

Installed Denton pricing per unit.

Option	Installed cost	Pros	Cons
1/3 HP pedestal	$940 – $1,300	—	—
1/2 HP submersible	$1,300 – $1,700	—	—
Submersible with battery backup	$1,700 – $2,200	—	—
Dual pump with water-powered backup	$2,200 – $3,050	—	—

Where the money goes in Denton

A typical $1,500 Denton project, broken down by line item.

Labor0.45% · $7
Materials0.38% · $6
Permits & inspections0.05% · $1
Overhead & profit0.12% · $2

Common add-ons

Extras that show up on Denton quotes but rarely in the headline price.

Battery backup system

$390 – $1,200

New sump pit excavation

$490 – $1,750

Discharge line extension

$145 – $590

Interior drain tile

$2,950 – $9,800

Ways to save in Denton

Install backup power — most failures happen during storm outages.
Replace preventively at year 8 instead of after a flood.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Denton FAQs

Get a Denton price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your TX ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Denton research

Best sump pump installation companies in Denton Sump Pump Installation permits in Texas Sump Pump Installation near me All Texas prices

Sump Pump Installation cost near Denton

Sump Pump Installation cost in Dallas, TX

$614 – $2,550

Sump Pump Installation cost in Fort Worth, TX

$602 – $2,500

Sump Pump Installation cost in Plano, TX

$632 – $2,625

Sump Pump Installation cost in Frisco, TX

$638 – $2,650

Sump Pump Installation cost in Arlington, TX

$596 – $2,475

Sump Pump Installation cost in Irving, TX

$602 – $2,500

More Texas cities

McKinney Garland Houston Katy Sugar Land The Woodlands Pearland Pasadena

Other project costs in Denton

Fence Installation in Denton

$1,470 – $3,920

Roof Replacement in Denton

$8,330 – $33,320

Kitchen Remodel in Denton

$17,640 – $93,100

HVAC Replacement in Denton

$5,390 – $17,640

Deck Building in Denton

$4,312 – $11,760

Window Replacement in Denton

$441 – $1,470

See every Denton cost guide