How much does cabinet refacing cost in Houston, TX?

Most Houston homeowners spend between $2,500 – $8,800 on cabinet refacing, with an average around $5,650. Local labor prices right at the national average, so Houston quotes tend to land at the higher end of national ranges.

Why is cabinet refacing more or less expensive in Houston than elsewhere?

Houston has the deepest trade labor pool in Texas, keeping bids near the national average. Humidity, hurricanes and flooding drive moisture-resistant and wind-rated specs.

Do I need a permit for cabinet refacing in Houston, Texas?

Houston has no zoning but permits are required for structural, electrical and mechanical work. Always confirm current requirements with the local building department before signing a contract, and make sure the permit is pulled by your licensed contractor.

How many quotes should I get in Houston?

Get at least three written quotes from licensed, insured Texas contractors. Comparing line items — not just the bottom line — is the fastest way to spot an inflated bid in the Houston market.

How much does cabinet refacing cost in 2026?

Most homeowners pay between $2,500 and $8,800, with a national average near $5,650. Small, simple jobs land at the low end; large or premium-material jobs run well above the high end.

What is the cost per linear foot?

Installed pricing usually runs $100.00 to $350.00 per linear foot, including labor and materials. Expensive metros can run 15–45% higher than that range.

What drives the price up the most?

Scope and access. Larger quantities lower your per-linear foot price, but difficult access, demolition of existing work, structural repairs found mid-job, premium materials and rush scheduling each add 8–30%.

Permits are typically required when the work changes structure or ties into electrical, plumbing, gas or mechanical systems. Budget $75–$600 in most cities and confirm whether your contractor pulls it — unpermitted work can block a future home sale.

How long does the job take?

Most residential projects of this type finish in one to five working days once materials are on site. Custom orders, inspections and weather are the usual causes of delay.

How many quotes should I get?

Three. Bids on the same scope commonly vary 20–40%, and the middle bid with the strongest warranty and references is usually the best value — the cheapest bid often excludes prep, disposal or permits.

Home/Cost guides/Cabinet Refacing/Houston, TX

Houston · Texas

Cabinet Refacing cost in Houston, TX

Houston homeowners typically pay $2,500 – $8,800 for cabinet refacing. Local labor and materials price right at the national average.

Get my Houston estimate Use the Houston calculator

Houston average

$5,650

Typical low

$2,500

Typical high

$8,800

Per linear foot

$100 – $350

Sample ZIP

77002

What drives Houston pricing

Local labor

Houston has the deepest trade labor pool in Texas, keeping bids near the national average.

Permits & code

Houston has no zoning but permits are required for structural, electrical and mechanical work.

Climate & conditions

Humidity, hurricanes and flooding drive moisture-resistant and wind-rated specs.

Instant cost calculator

Adjust the inputs to see live pricing

Cabinet run (linear feet)25 linear feet

Quality / material level

Site access

Removal / prep work

Timing

Estimated project cost

$3,325 – $4,513

Most homeowners pay around $3,919

Compare quality / material level

Cost by material in Houston

Installed Houston pricing per linear foot.

Option	Installed cost	Pros	Cons
Rigid thermofoil	$140 – $190	—	—
Wood veneer	$190 – $250	—	—
Solid wood doors	$250 – $325	—	—
Custom paint-grade solid wood	$325 – $450	—	—

Where the money goes in Houston

A typical $5,650 Houston project, broken down by line item.

Labor0.45% · $25
Materials0.38% · $21
Permits & inspections0.05% · $3
Overhead & profit0.12% · $7

Common add-ons

Extras that show up on Houston quotes but rarely in the headline price.

New hardware

$100 – $600

Soft-close hinges and slides

$200 – $900

Pull-out shelving

$150 – $500

Crown molding

$300 – $1,200

Ways to save in Houston

Reface only the uppers and paint the lowers for a two-tone look.
Reuse existing hardware if the hole spacing matches.
Collect three written bids on an identical scope — spreads of 20–40% are normal.
Book in the off-season and stay flexible on the start date to save 5–15%.
Bundle nearby work into one mobilization so you only pay setup and travel once.
Ask what the contractor would change to cut 10% without hurting durability.

Houston FAQs

Get a Houston price you can budget against

Answer a few questions about your project and we'll model a low, average and premium price for your TX ZIP code — then connect you with vetted local pros.

Get free quotes from certified pros

More Houston research

Best cabinet refacing companies in Houston Cabinet Refacing permits in Texas Cabinet Refacing near me All Texas prices

Cabinet Refacing cost near Houston

Cabinet Refacing cost in Katy, TX

$2,575 – $9,064

Cabinet Refacing cost in Sugar Land, TX

$2,625 – $9,240

Cabinet Refacing cost in The Woodlands, TX

$2,675 – $9,416

Cabinet Refacing cost in Pearland, TX

$2,525 – $8,888

Cabinet Refacing cost in Pasadena, TX

$2,425 – $8,536

Cabinet Refacing cost in Spring, TX

$2,500 – $8,800

More Texas cities

Dallas Fort Worth Plano Frisco Arlington Irving McKinney Denton

Other project costs in Houston

Fence Installation in Houston

$1,500 – $4,000

Roof Replacement in Houston

$8,500 – $34,000

Kitchen Remodel in Houston

$18,000 – $95,000

HVAC Replacement in Houston

$5,500 – $18,000

Deck Building in Houston

$4,400 – $12,000

Window Replacement in Houston

$450 – $1,500

See every Houston cost guide